rotary car build

diabolical1 · 01-19-2011, 09:18 PM

welcome to the board.

if you do decide on the rotary engine for your project, i guess my first question would be, does the Sierra transmission have a removable bell housing? if so, you could probably get a Turbo II transmission and see if you could find a way to adapt the bell housing to fit. i know it's probably easier said than done though. the only other thought that comes readily to my mind is use the transmission from a B-series truck because i know people have put rotaries in them many times over.

obviously, you're likely looking at custom driveshafts either way.

good luck.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-19-2011, 09:18 PM	#3
diabolical1 I have radioactive semen Join Date: Jul 2008 Location: in a bottle of Glenfiddich Posts: 250 Rep Power: 18	welcome to the board. if you do decide on the rotary engine for your project, i guess my first question would be, does the Sierra transmission have a removable bell housing? if so, you could probably get a Turbo II transmission and see if you could find a way to adapt the bell housing to fit. i know it's probably easier said than done though. the only other thought that comes readily to my mind is use the transmission from a B-series truck because i know people have put rotaries in them many times over. obviously, you're likely looking at custom driveshafts either way. good luck.