Component tweeter installation locations on an FC

[TitaniumTT]

Originally Posted by JustJeff

Pete

If I were you I'd fab up something out of fiberglass resin. First cut and tape some cardboard in the shape that will work best for you. Then paint the resin on it with some woven fiberglass. Leave the back that will contact the trim open. Once it's hardened you can take a dremel bit and sand out the cardboard. You can cut a hole for your tweeter and lay some vinyl that matches the interior.

Thats how I was considering doing mine. Then I realized the pods face the tweeters perfectly. That's when sinking one screw each through my door panels was alot more convenient than fabbing up a panel.

Instead of cutting up some cardboard, smear some wax over the stock plastic, then cover it with some wax paper, TIGHTLY. Apply the resin and mat ( I would use mat for the first layer, and woven for subsequent) one time and let it harden. Pop it out and now you have a mold of the original stock piece. From there, the skies the limit with where you can go with it.