Looking for some help in NC

LunchboxCritter · 08-22-2010, 12:54 PM

Just download the FSM, get an engine hoist, a set of metric sockets, and a digital camera. If you run across something you are unsure about snap some pictures and then post them on the forum. You'll usually get almost immediate response from fellow members.

It's a fairly simple task to pull the engine.
If the wiring is concerning you, make sure you label everything as you disconnect it. A little common sense will go along way.

Be sure to take plenty of pictures while you remove things so you have a reference to go back to if you forget during reassembly.

08-22-2010, 12:54 PM	#5
LunchboxCritter Simply Rotarded Join Date: Jan 2009 Location: Florida Posts: 166 Rep Power: 17	Just download the FSM, get an engine hoist, a set of metric sockets, and a digital camera. If you run across something you are unsure about snap some pictures and then post them on the forum. You'll usually get almost immediate response from fellow members. It's a fairly simple task to pull the engine. If the wiring is concerning you, make sure you label everything as you disconnect it. A little common sense will go along way. Be sure to take plenty of pictures while you remove things so you have a reference to go back to if you forget during reassembly. __________________ LunchboxCritter - 91 NA to J-Spec TII - 88 FC Vert - 04 Rx8 Disclaimer: I am not a mechanic, and I did not sleep at a Holiday Inn. DO NOT TRY THIS AT HOME!!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode