Clutch Questions

Kentetsu · 08-10-2010, 01:01 PM

Why would a certain type of clutch blow your tranny? I think you should've left the first clutch in there, you would've been fine.

As to why the new one is slipping; when you installed it, did you have the flywheel resurfaced? If not, then that is probably why. It would also explain the chatter.

Here are the details on my clutch problem, and the reasons for the failure. There are also details on what clutch I went with, and on the lightweight flywheel I installed while I was at it. This might help to answer some of your questions.

http://www.rx7club.com/showthread.php?t=867870

.

08-10-2010, 01:01 PM	#1
Kentetsu RCC Contributor Join Date: Feb 2008 Location: Grand Rapids, Michigan Posts: 530 Rep Power: 18	Why would a certain type of clutch blow your tranny? I think you should've left the first clutch in there, you would've been fine. As to why the new one is slipping; when you installed it, did you have the flywheel resurfaced? If not, then that is probably why. It would also explain the chatter. Here are the details on my clutch problem, and the reasons for the failure. There are also details on what clutch I went with, and on the lightweight flywheel I installed while I was at it. This might help to answer some of your questions. http://www.rx7club.com/showthread.php?t=867870 . __________________ "Learn from the past, or it will become your future...." '85 GS 12a + LSD/Sterling carb/Respeed coilovers/Respeed front swaybar/Respeed adj. rear spring perches/Illuminas/Bilsteins on rear AutoX vids @ http://www.youtube.com/user/Kentetsu1

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode