Making your own seat brackets?

infernosg · 07-23-2010, 07:50 PM

Ugh, so even after swapping out the 3/4" square tubing for 1/4" flat stock the driver's seat is still too high. With my helmet on my head hits the roof and I'm not a very tall person (5'-10" at best). Even though I dislike them I am seriously considering the Wedge brackets and Sparco sliders, but I don't know if that setup would be any lower.

Does anyone know if side-mounted seats are any higher/lower than the reclineables? Lately I've been considering selling the Torino II's and picking up something FIA approved like the Evo. Anyone have the Evo's or something similar in an FC?

07-23-2010, 07:50 PM	#12
infernosg IT'S ALIVE! Join Date: Dec 2009 Location: Richmond, VA Posts: 811 Rep Power: 16	Ugh, so even after swapping out the 3/4" square tubing for 1/4" flat stock the driver's seat is still too high. With my helmet on my head hits the roof and I'm not a very tall person (5'-10" at best). Even though I dislike them I am seriously considering the Wedge brackets and Sparco sliders, but I don't know if that setup would be any lower. Does anyone know if side-mounted seats are any higher/lower than the reclineables? Lately I've been considering selling the Torino II's and picking up something FIA approved like the Evo. Anyone have the Evo's or something similar in an FC? __________________ '86 Mazda RX-7 Base '79 Mazda RX-7 GS Last edited by infernosg; 07-23-2010 at 08:37 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode