looking for IC parts

speedjunkie · 05-29-2010, 03:12 PM

I know this isn't rotary specific but I didn't know where else to put it.

Anyway, as the title says, I'm looking for a website or something that has intercooler parts. The reason being that my current IC end tanks are not efficient and I want to make a new one. Take a look at the pic to see for yourself...

I'd like to have some end takes similar to this...

...but I'd like to see what else is out there before I commit myself to these, and actually if they could flow a bit smoother than these I'd like that too, maybe have more of an angle where the air enters and exits. If I can't find anything closer to what I need then I'll definitely get these though because they're already leaps and bounds better than what I have now.

I've done google searches and so far I haven't seen anything like what I need, and until I do, it leads me to believe I need to have it made.

Also, I think I read something within the last couple months or so about a new IC core design, has anyone heard anything about that? Supposedly it's better than bar and plate. I could be mistaken, it's been a while since I read it and I'm probably just "remembering" things that don't actually exist haha.

speedjunkie · 06-05-2010, 07:12 PM

After looking through pages and pages of crap I think I might have found some stuff that should work.

http://www.avoturbo.com/avoshop/inde...th=170_178_204

Some of it is kinda expensive and it's in Australia, but some of them are dead on for size.

05-29-2010, 03:12 PM	#1
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	looking for IC parts I know this isn't rotary specific but I didn't know where else to put it. Anyway, as the title says, I'm looking for a website or something that has intercooler parts. The reason being that my current IC end tanks are not efficient and I want to make a new one. Take a look at the pic to see for yourself... I'd like to have some end takes similar to this... ...but I'd like to see what else is out there before I commit myself to these, and actually if they could flow a bit smoother than these I'd like that too, maybe have more of an angle where the air enters and exits. If I can't find anything closer to what I need then I'll definitely get these though because they're already leaps and bounds better than what I have now. I've done google searches and so far I haven't seen anything like what I need, and until I do, it leads me to believe I need to have it made. Also, I think I read something within the last couple months or so about a new IC core design, has anyone heard anything about that? Supposedly it's better than bar and plate. I could be mistaken, it's been a while since I read it and I'm probably just "remembering" things that don't actually exist haha.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-05-2010, 07:12 PM	#2
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	After looking through pages and pages of crap I think I might have found some stuff that should work. http://www.avoturbo.com/avoshop/inde...th=170_178_204 Some of it is kinda expensive and it's in Australia, but some of them are dead on for size.