Half bridge port on stock ecu.

N.RotaryTech · 06-02-2010, 06:58 PM

The bridge port could of been made bigger.
I only made it 1/8 inch. I should of made it 3/16 inch.

I probably will redo it over again sometime. Hopefully nothing will majorly blow up inside.
Bigger bridge port area. Maybe a full bridge. With new water seals, one piece apex seals, maybe solid corner seals. Etc.

Future plans?
Megasquirt, rebuild as mention above, turbo application.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-02-2010, 06:58 PM	#11
N.RotaryTech Home-brew Rotary Join Date: Feb 2008 Location: GooseCreek SC Posts: 552 Rep Power: 18	The bridge port could of been made bigger. I only made it 1/8 inch. I should of made it 3/16 inch. I probably will redo it over again sometime. Hopefully nothing will majorly blow up inside. Bigger bridge port area. Maybe a full bridge. With new water seals, one piece apex seals, maybe solid corner seals. Etc. Future plans? Megasquirt, rebuild as mention above, turbo application.