Question about RA OMP adapter and S5 OMP

need RX7 · 03-07-2010, 12:58 AM

So, I've pretty much decided that I'll be running an S5 engine in my car in the future, and I'd like to run an S5 omp with a Rotary Aviation OMP adapter so I can inject 2-stroke oil instead of dirty sump oil, and also not have to deal with the throttle linkage of the S4 omp. *I plan on having a Haltech Platinum Sport 1000 by then, which does support an electronic OMP.

I've noticed in Rotary Aviation's OMP adapter listing that they don't offer one for an electronic 2nd gen OMP, only mechanical 2nd gen pumps and electronic 3rd gen pumps.
However, I also noticed that Pineapple Racing lists their OMP block-off plate as fitting both 2nd gen and 3rd gen electronic pumps, which means they must have the same bolt pattern.

So, my main question is; Could I use RA's 3rd gen electronic OMP adapter with a series 5 OMP and front cover? Their bolt pattern appears to be the same, but I suppose there could be a difference between the driveshaft(?) locations, or perhaps something else I don't know about?

SecondGenPat · 03-08-2010, 05:04 PM

you may want to give them a call to see if the pump adapter is still offered.
I could have sworn that they discontinued them because of low demand.
But I could be (and most probably am) wrong.

-Pat

03-07-2010, 12:58 AM	#1
need RX7 Clean S4 Nutswinger Join Date: Mar 2008 Location: Sterling Heights, MI iTrader: (0) Posts: 485 Rep Power: 17	Question about RA OMP adapter and S5 OMP So, I've pretty much decided that I'll be running an S5 engine in my car in the future, and I'd like to run an S5 omp with a Rotary Aviation OMP adapter so I can inject 2-stroke oil instead of dirty sump oil, and also not have to deal with the throttle linkage of the S4 omp. I plan on having a Haltech Platinum Sport 1000 by then, which does support an electronic OMP. I've noticed in Rotary Aviation's OMP adapter listing that they don't offer one for an electronic 2nd gen OMP, only mechanical 2nd gen pumps and electronic 3rd gen pumps. However,* I also noticed that Pineapple Racing lists their OMP block-off plate as fitting both 2nd gen and 3rd gen electronic pumps, which means they must have the same bolt pattern. So, my main question is; Could I use RA's 3rd gen electronic OMP adapter with a series 5 OMP and front cover? Their bolt pattern appears to be the same, but I suppose there could be a difference between the driveshaft(?) locations, or perhaps something else I don't know about? __________________ -Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress.

03-08-2010, 05:04 PM	#2
SecondGenPat Start a Revolution Join Date: Feb 2009 Location: Park Ridge, NJ iTrader: (0) Posts: 29 Rep Power: 0	you may want to give them a call to see if the pump adapter is still offered. I could have sworn that they discontinued them because of low demand. But I could be (and most probably am) wrong. -Pat __________________ That to secure these rights, Governments are instituted among Men, deriving their just powers from the consent of the governed, — That whenever any Form of Government becomes destructive of these ends, it is the Right of the People to alter or to abolish it, and to institute new Government -The United Stated Declaration of Independence

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode