NRS FD Ceramic Seals for the RX8

thewird · 12-28-2009, 03:11 PM

Is what your referring to a machining error? As it needs to be a very accurate/precise machining process? So it being the machinists fault and not the rotor itself?

When machining an FD rotor to 3mm, there have been many cases where machinists don't get it spot on and trash the rotors. But this has to do with the machinist you go to. Once you find the right machinist, trashing rotors is no longer a problem.

Just trying to figure out why. Thanks.

thewird

12-28-2009, 03:11 PM	#14
thewird Rotary Fan in Training Join Date: Mar 2008 Location: Toronto, Canada Posts: 37 Rep Power: 0	Is what your referring to a machining error? As it needs to be a very accurate/precise machining process? So it being the machinists fault and not the rotor itself? When machining an FD rotor to 3mm, there have been many cases where machinists don't get it spot on and trash the rotors. But this has to do with the machinist you go to. Once you find the right machinist, trashing rotors is no longer a problem. Just trying to figure out why. Thanks. thewird __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode