Lots of fuel in oil

BigIslandSevens · 12-07-2009, 03:07 PM

550 Primaries 1300 secondaries PFC tuned for my previous 62-1 stock port single set-up. Never had an issue before. Porting is the only "big" change. But I can't figure how the fuel is getting into the oil unless I have a stuck seal allowing it to wash by.

I am really thinking I did something to my primary ports. I am getting a replacement center iron( at least) and tearing it open in a month or so. Any ideas for what to look for are appreciated.

Dave

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-07-2009, 03:07 PM	#5
BigIslandSevens Rotary Fanatic Join Date: Feb 2008 Location: Denver, NC Posts: 201 Rep Power: 18	550 Primaries 1300 secondaries PFC tuned for my previous 62-1 stock port single set-up. Never had an issue before. Porting is the only "big" change. But I can't figure how the fuel is getting into the oil unless I have a stuck seal allowing it to wash by. I am really thinking I did something to my primary ports. I am getting a replacement center iron( at least) and tearing it open in a month or so. Any ideas for what to look for are appreciated. Dave