Kinugawa FC3S turbo oil feed line

[Pete_89T2]

Originally Posted by RETed

I was kinda forced to get this, because I just could not get the stock turbo oil feed flange to seal on top of the turbo.
Oil leaking from here drips down the center housing and gets on the turbo exhaust manifold, which then burns and smokes...
Even after multiple attempts with the stock Mazda gasket, I looked for an alternative...

Interesting, I've never had a problem getting that stock flange joint to seal up properly, never had a leak there. Perhaps your flange or turbo mating surface was warped or misaligned somehow?


I just use the factory paper/fiber gasket, with a very thin & even skin coat of blue Hylomar on both sides of the gasket & torque bolts to FSM spec. My current BNR turbo setup needed an oil pressure restrictor to prevent smoking, so I fabricated an 0.096" thick AL restrictor plate and sandwiched it between the oil feed pipe flange & turbo with gaskets on all mating surfaces. Needed slightly longer bolts, but it still doesn't leak, which shocked the hell out of me.