Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-12-2015, 03:05 PM   #34
Pettersen
Rotary Fanatic
 
Join Date: Mar 2010
Location: Norway
Posts: 163
Rep Power: 16
Pettersen is on a distinguished road
Yup, just took forever to get it done, and the intake design changed many times...

They are 4*42mm tb's from a Gsxr 1000.

I have changed injectors so the map is no where near where it needs to be, could not even get it to rev above 3500-4k because it drowned. Will fix it this summer, and get it on the dyno. Realy looking forward to hearing how it sounds under load at high rpm.

I'm currently finishing up my second year of my three year mechanical engineering degree, so turbo will have to wait untill i start getting some paychecks.
Planning on fabricating a plenum next, so i might just have to make shure it will be strong enough to handle boost in the future. Only issue would be to fit the turbo, the runners on the itb manifold only have a 30 degree rise, so the turbo manifold would need to extend almost to the radiator.

Last edited by Pettersen; 04-12-2015 at 03:44 PM.
Pettersen is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:15 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com