5th & 6th port repair and clean up

[WE3RX7]

I cleaned all the parts of oil/coolant/carbon before coating them.

The block has coolant dripping down it due to that line being undone. After I hook it all back up I'm going to spray it down with some carb clean/degreaser.

I felt in as far as I could and using a light w/ mirror to verify the sand situation... it doesn't appear that any made it past the entrance of the sleeves. Now, that doesn't speak for the main ports that have no sleeves, its possible some got sucked through there.

The car runs fine though besides the port being stuck, so I'm not too worried. If the car doesnt sell because somebody is worried about the engine, its not the end of the world. I'll store it til next summer and do a rebuild then...