Tegheim - Home made 4 rotor Wolvo 142

Tegheim · 02-16-2013, 02:22 PM

Today I've used the cnc-lathe again. Fun to learn, but very time consuming.

These are for the 4-link, and fit the RERS-4 rubber protection. I made these in stainless.

Then I also turned a new mount for the rear coilovers.
Really fun to turn threads in a cnc. They always look so good.

M12x1.75 at one end, Ø12.75mm for the coilover, and then M20x1.5 in the other end.

Ofcource I was at the garage to try them out!

02-16-2013, 02:22 PM	#11
Tegheim Rotary Fanatic Join Date: Feb 2011 Posts: 210 Rep Power: 15	Today I've used the cnc-lathe again. Fun to learn, but very time consuming. These are for the 4-link, and fit the RERS-4 rubber protection. I made these in stainless. Then I also turned a new mount for the rear coilovers. Really fun to turn threads in a cnc. They always look so good. M12x1.75 at one end, Ø12.75mm for the coilover, and then M20x1.5 in the other end. Ofcource I was at the garage to try them out!