|
|||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
|
|
Thread Tools | Display Modes |
|
|||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
|
|
Thread Tools | Display Modes |
02-01-2012, 11:48 AM
|
#8 |
|
FC3S
Join Date: Jun 2010
Location: Townsville, QLD, AUS
Posts: 326
Rep Power: 16  |
One thing I have found (note I get aircraft grade wire and connectors for free from work) is that the special heat shrink on environmental splices requires too much heat for generic wire, it melts the insulation before the splice seals. And the mil spec wire certainly solders alot better if you choose that route.
|
|
|
| Bookmarks |
|
|
Threaded Mode