Re-using stock seals

[RETed]

Apex seals generally need to be changed, especially on an original motor.
Check with FSM, but I think they are:
8.0mm new
7.5mm replace with new inner apex seal spring
7.0mm wear limit - replace apex seal

Side seals in general don't need to be replaced - FSM has wear limits.

Corner seals are the same as side seals.

If side or corner seals are out of spec, I'd question if the engine was overheated or loss of oil pressure or no oil injection / premix.
Excessive side and corner seals imply internal lubrication is inadequate.


-Ted