N/A 20b build

project86 · \r\n \r\n \r\n 06-17-2010, 12:06 PM\r\n \r\n \r\n

So I've been emailing back and forth with Adam from RX7Specialites in Calgary, AB about a 20b N/A build. It seems like he wants me to do a ton of extra things that I don't know if I need or not. Basically, I'm going to be building a fun street car that I will take to HPDE once in a while. What I want is a large streetported 9.7:1, balanced to 9000RPM engine. He wants me to go with new housings and says new rotors are a necessity. Do I really need all of this for a 300whp N/A build?

He suggested the following in an email...

Quote:

New 13B housings, new S5 rotors, 20b hardened gears, Lighten, clearance and balance rotating assy (which I will do) Oil mods incl HP race oil reg. Bridge porting 20b (pri and sec) $1117.50 (incl std intake port and polish, exhaust porting and bridge work).

I figured a standard 9.7:1 build with S5 rotors, a LARGE street port and balancing would be good. Should I be doing oil mods? Race bearings? Scalping the rotors? He suggested a bridge port... not sure if I want to go that extreme.

I know he knows what he's talking about and I'm sure it would be a KILLER engine. But... it's all about dollars and cents.

What do I need to build a 350whp ITB'd street ported 20b?

I'm going to be runnign a Microtech, have some equal length headers built by a friend who is a fab king and most likely use the Hinson subframe with their bumpsteer kit.

Any input would be appreciated.

Thanks...

Aaron from Canada

\r\n \r\n \r\n 06-15-2010, 02:26 PM\r\n \r\n \r\n	\r\n \r\n #2\r\n \r\n
\r\n\r\n \r\n \r\n project86\r\n \r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n
\r\n \r\n\r\n\r\n \r\n \r\n \r\n \r\n \r\n	\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n