epoxy + exhaust sleeve...

sen2two · 10-06-2009, 01:24 PM

Im gonna be using this in the exhaust area and also my coolant area. didnt know if anyone here as used it. JB weld and devcon have a temp rating of about 500-600* F. this stuff is labeled as 2400* F and claims to increase in strength with heat. if normal exhaust temps are usually around 1600-1700*, this stuff should be fine. so this is great stuff if you would like to remove your exhaust sleeve and reshape one out of epoxy. might work wonders...

anyone have experience with this?

http://automotive-oilsandfluids.blog...high-temp.html

10-06-2009, 01:24 PM	#1
sen2two KTEC Join Date: Jan 2009 Posts: 642 Rep Power: 0	epoxy + exhaust sleeve... Im gonna be using this in the exhaust area and also my coolant area. didnt know if anyone here as used it. JB weld and devcon have a temp rating of about 500-600* F. this stuff is labeled as 2400* F and claims to increase in strength with heat. if normal exhaust temps are usually around 1600-1700, this stuff should be fine. so this is great stuff if you would like to remove your exhaust sleeve and reshape one out of epoxy. might work wonders... anyone have experience with this? http://automotive-oilsandfluids.blog...high-temp.html __________________ what I have:* 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode