Engine Install Check

		Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)
Engine Install Check

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

\r\n

\r\n\r\n

\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n

\r\n \r\n

\r\n 07-25-2009, 05:40 PM\r\n \r\n \r\n

\r\n \r\n #2\r\n \r\n

\r\n\r\n

\r\n \r\n 87TurboII\r\n

07-25-2009, 04:47 PM	#1
87TurboII Rotary Fan in Training Join Date: Jul 2008 Location: Texas iTrader: (0) Posts: 45 Rep Power: 0	Engine Install Check This is a stupid question I am sure but I would hate to put it all back together just to find out something is not right. I pulled the old blown engine and just installed the new engine. I did not pull the transmission so I had to try and align it and slide it onto the transmission. Is there a way to see if they are all together properly? the engine is up against the transmission so I assume the splines on the clutch and transmission must be aligned but should the rear tires spin if the eccentric shaft is turned whiles its in gear? Just want to double check with others who have probably done this more times than me. Thanks __________________ 1987 Turbo II

Bookmarks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 11:08 AM.