Changing twins and.......?

AHarada · 04-04-2009, 07:33 PM

I am changing my twins to a good set, and one of the bolts holes isn't lining up. The gaskets are centered, and all of the bolt holes are centered except for one. It's the lower of the 2 longer bolts. It's off by a good 2mm and I don't see how it could line up. The seller of these told me they came off of his car so they can't be cosmo turbos. Has anyone experienced this? Any suggestions? Is there going to be an exhaust leak if I leave this bolt out?

04-04-2009, 07:33 PM	#1
AHarada Rotary Fanatic Join Date: Mar 2008 Posts: 162 Rep Power: 17	Changing twins and.......? I am changing my twins to a good set, and one of the bolts holes isn't lining up. The gaskets are centered, and all of the bolt holes are centered except for one. It's the lower of the 2 longer bolts. It's off by a good 2mm and I don't see how it could line up. The seller of these told me they came off of his car so they can't be cosmo turbos. Has anyone experienced this? Any suggestions? Is there going to be an exhaust leak if I leave this bolt out?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode