Need a T2 Front Iron/How to grind out diffuser

		Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)
Need a T2 Front Iron/How to grind out diffuser

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

\r\n

\r\n\r\n

\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n

\r\n \r\n

\r\n 01-07-2009, 10:52 PM\r\n \r\n \r\n

\r\n \r\n #2\r\n \r\n

\r\n\r\n

\r\n \r\n NoDOHC\r\n

01-02-2009, 04:24 PM	#1
TehMonkay Rotary Fanatic Join Date: Apr 2008 Location: Louisville, KY iTrader: (0) Posts: 302 Rep Power: 17	Need a T2 Front Iron/How to grind out diffuser I need 1 T2 front iron, the motor it's going on is all S5 stuff except the rear iron, but I don't think it matters too much as long as it hasn't been bridged, it's going in a street port motor. One i had got cut a little too deep. Also, what should I do to grind out a diffuser(n/a housing)? Can i use an electric drill? What kind of bit should i use? __________________ My car blows up everytime I start it, it's rotary

Bookmarks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 11:13 AM.