|
RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
Thread Tools | Display Modes |
\r\n \r\n \r\n 11-16-2008, 07:43 AM\r\n \r\n \r\n | \r\n\r\n \r\n #2\r\n \r\n | \r\n \r\n
\r\n\r\n Guest \r\n \r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n \r\n \r\n \r\n \r\n \r\n Posts: n/a\r\n \r\n\r\n \r\n \r\n \r\n \r\n | \r\n \r\n \r\n\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n\r\n \r\n\r\n \r\n \r\n if the rotor was not spinning true I would suggest either the rotor is not sitting flush on the hub (build up on the hub that was not cleaned off properly before installation of the new disc) \r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n \nOtherwise it is possible you have bad wheel bearings. \n \nDo you have any pic of the "grooving" I mean you say the "wheels" inside hub.. I guess I don\'t understand what part u are talking about.\r\n | \r\n
\r\n \r\n \r\n \r\n \r\n \r\n \r\n | \r\n \r\n\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n | \r\n
\r\n \r\n \r\n 11-16-2008, 12:13 PM\r\n \r\n \r\n | \r\n\r\n \r\n #3\r\n \r\n | \r\n \r\n
\r\n\r\n | \r\n|
\r\n \r\n\r\n\r\n \r\n \r\n \r\n \r\n \r\n | \r\n \r\n\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n | \r\n
\r\n \r\n \r\n 12-09-2008, 06:17 PM\r\n \r\n \r\n | \r\n\r\n \r\n #17\r\n \r\n | \r\n \r\n
\r\n\r\n |