Won"t hold fuel pressure?

[David Jerome]

Originally Posted by phantomworks

I replaced the TPS, spark plugs and plug wires, and still no start. I had fuel and spark at this time so I went through all my fuses, relays, grounds, and every thing checked out.

So I decided to do a compression check a few weeks later, when I pulled the plugs i noticed I had no fuel on the fresh plugs, they still looked brand new, so I checked for spark again and there was none.
Well this led me to believe that it was the CAS's I pulled and checked them and they read 1.12 and 1.15 ohms which is well within spec but I replaced them with another set anyway and they read 1.14 and 1.19ohms but still nothing. the rpm needle does bounce alittle when trying to start which tells me the injectors are receiving a signal .

The comppresion was good btw I'm pretty stumped at this point

Did you install new plugs and verify you have spark?