Dropping in motor. Lining up input shaft with pilot bearing?

		Rotary Car Club > Tech Discussion > RX-7 3rd Gen Specific (1993-2002)
Dropping in motor. Lining up input shaft with pilot bearing?

RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections.

\r\n

\r\n\r\n

\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n

\r\n \r\n

\r\n 08-10-2008, 10:14 PM\r\n \r\n \r\n

\r\n \r\n #2\r\n \r\n

\r\n\r\n

\r\n \r\n FerociousP\r\n

08-10-2008, 10:00 PM	#1
AHarada Rotary Fanatic Join Date: Mar 2008 iTrader: (1) Posts: 162 Rep Power: 17	Dropping in motor. Lining up input shaft with pilot bearing? I'm dropping in my motor right now. I can't get the input shaft of the tranny to slide into the pilot bearing. I have the motor mounts off the engine to allow more room for moving the motor around. I have the clutch attached to the engine and the downpipe also. How far should I jack up the tranny? Should I take the clutch off the motor and put it in the tranny and use the peek hole to bolt it up to the flywheel? Do I need to press the clutch in or something? I can't figure out what I'm missing.

Bookmarks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 06:38 AM.