Troubleshooting your fuel level sender

JL1RX7 · 07-17-2015, 04:06 AM

Now since it is a averaging sensor I wonder if it only takes input from certain OHM readings. So say anything above 90 OHM it only reads from one side vs the other.

Most of the sensor's I use are for temperature across a large area. Not a split sensor system like this. But trying to see the logic of what they are trying to read, then using a sensor to read it. I could see it doing something like that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-17-2015, 04:06 AM	#9
JL1RX7 Rotary Fanatic Join Date: Feb 2008 Location: Front Royal, VA Posts: 487 Rep Power: 18	Now since it is a averaging sensor I wonder if it only takes input from certain OHM readings. So say anything above 90 OHM it only reads from one side vs the other. Most of the sensor's I use are for temperature across a large area. Not a split sensor system like this. But trying to see the logic of what they are trying to read, then using a sensor to read it. I could see it doing something like that.