Bubble Tech FD Cooling plate

[muibubbles]

We've been getting a bunch of request to develop a cooling panel/plate so here it isss...
EAT YOUR HEART OUT.


(Prototype)

10 Reasons why ours better then the rest?
1. Because our cut outs for the rubber bump stops are circular, not square.. Go figure, it makes sense!
2. Our A/C cut out, its designed around the A/c, not just a huge cut out.
3. Our fitment is spot on so you dont need to have ugly screws holding it in place, this is suppose to clean up the look too, right?
4. "We'll Benny, what if it vibrates or moves around, blah blah blah,"-- Read the above comment Chief, need not worry, ITS ALSO MAGNETIC.
5. YUP, We teamed up Billy Nye the Science guy and we embedded tiny neodymium magnets on the back to be 100% sure it wont move around, Step yo nerd game up foo'
6. Unfortunately they are still made by an Asian sweat shop laborer, but at least hes locked up in a garage in NJ, THUS, MADE IN USA Wahooo!
7. Its CLEAR COATED, not those "UV RESISTANT gel coat" that will yellow and fade over time.
8. Because I said so.
9. Because we're awesome.
10. Because it comes with a free hug if you pick up!

**Note the cooling plate is not properly seated in these pics dude to the car having some stuff in the way under the cooling plate-- these were just taken to confirm the FMIC cutout location!





Carbon Fiber sample (note our prototype picture on top is NOT clear coated hence why its lacking that liquid luster<3)




Base panels will come with cut outs for the hood latch and rubber bump stops Optional: notch for hood prop
Fiberglass $175
Carbon Fiber $275

cut out options- Add $5 Each cut
A/c cut out
Greddy FMIC IC pipe cut out
http://www.bubbletech.us/ProductDeta...e=CoolingPlate