NA 6 port half bridge build (zenki FC)

Tougemonster · 12-01-2012, 03:21 AM

So i kinda jus did my own thing cus everyone told me it wouldnt work well
I made a template using the pineapple large streetport for a 6 port
the template has a 32mm bridge on the secondaries only,its chamfered to about 34mm
the bridge is 5.5mm wide and the port goes to 1.5mm from the coolant seal and the housings are notched to match
Im still on a stock ECU i went with rebuilt injectors and used 550cc/min secondaries
I used cnc'd atkins aux port sleeves and just leave em open for now
all the intake runners were smoothed of casting crap TB was ported
I posted most of my buildup on the other forum.
http://www.rx7club.com/build-threads...ki-fc-1009424/

http://youtu.be/JcGz6iHgXb0

12-01-2012, 03:21 AM	#11
Tougemonster Meat Popsicle Join Date: May 2010 Location: Missoula, MT Posts: 31 Rep Power: 0	So i kinda jus did my own thing cus everyone told me it wouldnt work well I made a template using the pineapple large streetport for a 6 port the template has a 32mm bridge on the secondaries only,its chamfered to about 34mm the bridge is 5.5mm wide and the port goes to 1.5mm from the coolant seal and the housings are notched to match Im still on a stock ECU i went with rebuilt injectors and used 550cc/min secondaries I used cnc'd atkins aux port sleeves and just leave em open for now all the intake runners were smoothed of casting crap TB was ported I posted most of my buildup on the other forum. http://www.rx7club.com/build-threads...ki-fc-1009424/ http://youtu.be/JcGz6iHgXb0 Last edited by Tougemonster; 12-02-2012 at 02:48 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode