Better Exhaust Gaskets

cewrx7r1 · 04-07-2008, 05:31 PM

I am using a FC turbo exhaust gasket which was cut in half to reduce flexing between both ports like the FD gaskets are. Cheaper and works fine with my GT35R on my 13B-REW FD engine.

If you are burning exhaust gaskets, you propably have a manifold that is not truely flat.
I had to have both faces of my A-Spec manifold trued because they were not flat. I have seen this same problem on other single turbo manifolds.

Don't blame the messenger!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-07-2008, 05:31 PM	#9
cewrx7r1 The Judge Join Date: Feb 2008 Posts: 196 Rep Power: 18	I am using a FC turbo exhaust gasket which was cut in half to reduce flexing between both ports like the FD gaskets are. Cheaper and works fine with my GT35R on my 13B-REW FD engine. If you are burning exhaust gaskets, you propably have a manifold that is not truely flat. I had to have both faces of my A-Spec manifold trued because they were not flat. I have seen this same problem on other single turbo manifolds. Don't blame the messenger!