Stationary Gear Bearings...replace both?

		Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)
Stationary Gear Bearings...replace both?

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

\r\n

\r\n\r\n

\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n

\r\n \r\n

\r\n 03-08-2011, 05:23 PM\r\n \r\n \r\n

\r\n \r\n #2\r\n \r\n

\r\n\r\n

\r\n \r\n N.RotaryTech\r\n

03-08-2011, 05:14 PM	#1
JustJeff RCC Contributor Join Date: Mar 2008 iTrader: (1) Posts: 505 Rep Power: 17	Stationary Gear Bearings...replace both? Wanting opinions on what to do with these bearings. IIRC, but it was a while ago, I got advice that one of the bearings is useable because the wear isn't sharp. I had first thought I'd replace both bearings. Then got some advice that one of them is useable. I'm wondering if it's safer to keep a worn bearing rather than replace. Or should I simply replace both while doing it, seeing how the break in time is going to increase anyway. I'm going to order all my rebuild parts in the next few days and want to make sure I get all that I need.

Bookmarks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 05:46 AM.