|
Old School Rotary (Pre-1979) Pre-1979 Discussion including performance modifications and technical support sections |
|
Thread Tools | Display Modes |
![]() |
#1 |
KTEC
Join Date: Jan 2009
Posts: 642
Rep Power: 0 ![]() |
Need some help getting Rx2 metal...
I have been emailing, calling, and looking everywhere all over the country for someone willing to cut up there junk Rx2 to get some metal to fix my 72 coupe. I have found a few people who say they will, and then never come through.
So I'm asking now. This is what I need. Pics and descriptions below... So if you know someone or somewhere I can get this from, PM me asap or send them a link to this thread. This would be greatly appreciated. And would bring another Rx2 back to life!!! This is needed so i can weld in my new frame rails. I do not believe the metal there is strong enough for me to weld in good clean new metal. So i would like to replace it with un-rusted metal. What I need is inside the red lines below. I do not need it to be in one piece. What I mainly need is there area half way up the fire wall down to the seat bracket area. I need each side. I really don't need the trans tunnel. There must be ZERO rust on the metal. I'm located in Kissimee, Florida. ![]() I will also need both rear quarter panels and the lower rocker from front to rear on the passenger side. A clean set of front fenders would be nice also. Put the word out!!!
__________________
what I have: 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2 |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|