MSD 6al and s-2tep

		Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)
MSD 6al and s-2tep

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

\r\n

\r\n\r\n

\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n

\r\n \r\n

\r\n 08-21-2010, 12:51 AM\r\n \r\n \r\n

\r\n \r\n #2\r\n \r\n

\r\n\r\n

\r\n \r\n RETed\r\n

08-20-2010, 10:45 PM	#1
sen2two KTEC Join Date: Jan 2009 iTrader: (2) Posts: 642 Rep Power: 0	MSD 6al and s-2tep I'm running a Jacobs FC1000 right now, which is basically the same thing as a MSD 6a. I want to run a MSD 2-step so I can have a controlled launch every time. I have searched all over on how to put in a 2-step, and just about every thread or piece of information says something different. Very contradictory and confusing when trying to learn... So to make it easier on myself, I'm think of just swapping the FC1000 for a MSD 6al. Not the new 6al-2, but the older 6al. These come with a built in slot for a rev-limiter "pill". But i think instead of running a pill there, I can just plug an MSD 2-step in and be good to go. But the main problem I think is that I will have the 6al wired to my leading coil pack only. So will the 2-step work, or give me the same effect, if the trailing coils arnt touched at all by this? __________________ what I have: 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2

Bookmarks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 06:48 AM.