|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
03-28-2008, 12:59 PM
|
#6 |
|
Viable Fossil
Join Date: Mar 2008
Location: Mid-West
Posts: 199
Rep Power: 18  |
Just thinking out-loud here....and I'm in the middle of only my first rebuild so go easy....
What about potential carbon build-up in that corner seal slot. I see some clearance for length, but is there risk with loss of what little "side" clearance there is within that slot due to expansion and/or carbon? What would be the result of the side seal and corner seal being effectively fused together if that happened?
__________________
Jim VR R1 FD Last edited by Signal 2; 03-28-2008 at 01:07 PM. |
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode