|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
|
Thread Tools | Display Modes |
12-03-2014, 04:56 PM
|
#16 |
|
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18  |
The flanges never go above 500deg C, this is why some people get away with just using high temp silicone in these areas (its very common).
I posted the actual temp gradients above in post #1 as proof of this. That other internet search product, good luck applying it. This stuff I listed is approved and used by everyone, its a no brainer and it works  feel free to use it.
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
|
|
| Bookmarks |
|
|
Linear Mode
