How to remove OMP inlet nozzles on inlet manifold

RX MIDGET · 03-28-2011, 06:58 PM

Hi,
After disconnecting the OMP I am left with the 2 brass nozzlesbetween the 48IDA and manifold.

Is there a trick to removing them without damage?

Figure it would look better to remove them than cap them with silicone.

Thoughts?

rxtasy3 · 03-29-2011, 12:48 AM

probably just pressed in. would take some effort but should pull right out.

PercentSevenC · 03-29-2011, 12:12 PM

Personally, I'd just cap them.

RX MIDGET · 03-29-2011, 03:48 PM

I figure as they are brass, I will just cap them - otherwise could end up being an bent eye-sore.

03-28-2011, 06:58 PM	#1
RX MIDGET MG rocket Join Date: Oct 2010 Location: Victoria Australia Posts: 40 Rep Power: 0	How to remove OMP inlet nozzles on inlet manifold Hi, After disconnecting the OMP I am left with the 2 brass nozzlesbetween the 48IDA and manifold. Is there a trick to removing them without damage? Figure it would look better to remove them than cap them with silicone. Thoughts?

03-29-2011, 12:48 AM	#2
rxtasy3 rotary madness Join Date: Apr 2010 Location: spartanburg, sc Posts: 78 Rep Power: 16	probably just pressed in. would take some effort but should pull right out.

03-29-2011, 03:48 PM	#4
RX MIDGET MG rocket Join Date: Oct 2010 Location: Victoria Australia Posts: 40 Rep Power: 0	I figure as they are brass, I will just cap them - otherwise could end up being an bent eye-sore.