|
|
|
||||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
|
Thread Tools | Display Modes |
04-14-2014, 04:02 PM
|
#1 | |
|
Rotary Fanatic
|
Testing CAS signalI just finii
I just finished installing a MS2 system on my 86NA. Car ran fine the first day but then lost engine speed signal to my squirt box. The signal is supposed to be read off the CAS. I was told you can test it to make sure everythign is working properly and that the wires are in working condition by checking voltage in the wires while cranking the engine with a digital multimeter. Does anyone know approx how much voltage I should be seeing?
__________________
Quote:
|
|
|
|
|
04-14-2014, 05:40 PM
|
#2 | |
|
RCC Addict
|
You really need an o-scope to do this properly...
-Ted
__________________
reted_2000@yahoo.com Technical Advisor FC3S Pro http://fc3spro.com/ Quote:
|
|
|
|
|
Linear Mode
