Re installing motor. what to bolt on?

jahjahsqc · 10-29-2013, 01:02 PM

I've got my keg back and have the trans attached and starter in.

But how far do I need to go with installing attachments? exhaust mani? turbo? LIM? UIM?

This is the first rotary engine I've owned and I wasn't the one to tear this down so I don't know the best way to put it back together.

thanks!

Rotary Evolution · 10-29-2013, 01:53 PM

normally i install the turbo and lower manifold and that's about all before it goes into the engine bay.

everyone has their own preferred choice for installation procedures. just tape up all open ports and reassemble once it's inside the car.

jahjahsqc · 10-30-2013, 08:13 PM

excellent. thanks!

10-29-2013, 01:02 PM	#1
jahjahsqc Rotary Fan in Training Join Date: Sep 2013 Location: Winder, Ga iTrader: (0) Posts: 42 Rep Power: 0	Re installing motor. what to bolt on? I've got my keg back and have the trans attached and starter in. But how far do I need to go with installing attachments? exhaust mani? turbo? LIM? UIM? This is the first rotary engine I've owned and I wasn't the one to tear this down so I don't know the best way to put it back together. thanks!

10-29-2013, 01:53 PM	#2
Rotary Evolution rotaryevolution.net Join Date: Feb 2011 Location: Las Vegas, NV iTrader: (0) Posts: 248 Rep Power: 14	normally i install the turbo and lower manifold and that's about all before it goes into the engine bay. everyone has their own preferred choice for installation procedures. just tape up all open ports and reassemble once it's inside the car. __________________ http://rotaryevolution.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-30-2013, 08:13 PM	#3
jahjahsqc Rotary Fan in Training Join Date: Sep 2013 Location: Winder, Ga iTrader: (0) Posts: 42 Rep Power: 0	excellent. thanks!