Checking clutch arm/pressure plate

JL1RX7 · 10-21-2013, 05:43 PM

Unless you can get a boroscope in the vent hole. I can't think of anything without dropping the tranny.

The ball end of the slave is sitting snuggly in the fork right? Also not sloppy or funky sounds when you slide the fork back and forth? Got the system bled etc?

WankelsRevenge · 10-21-2013, 06:14 PM

Quote:

Originally Posted by JL1RX7

The ball end of the slave is sitting snuggly in the fork right? Also not sloppy or funky sounds when you slide the fork back and forth? Got the system bled etc?

Afirmitive on all of the above. Even went out and bought a vaccum bleeder to make sure everything was done right. I had a slow leak somewhere before I changed out my master/slave and now Im waiting untill tomorrow to check and make sure that problem is solved. I guess its just time to get it up on jackstands and see what I can find.

JL1RX7 · 10-21-2013, 06:20 PM

Unless someone else might have something. I can't think of anything without dropping the tranny. Sorry dude. Any pictures of thing? Maybe the fork is the wrong way around.

WankelsRevenge · 10-21-2013, 09:55 PM

Well I think I found the problem. Went to go do the finger trick Robert recomended. Well when I went to push the slave cylinder piston in, fluid came gushing out all over the place. So time to install yet another, and hope it fixes the problem.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-21-2013, 05:43 PM	#16
JL1RX7 Rotary Fanatic Join Date: Feb 2008 Location: Front Royal, VA iTrader: (1) Posts: 487 Rep Power: 17	Unless you can get a boroscope in the vent hole. I can't think of anything without dropping the tranny. The ball end of the slave is sitting snuggly in the fork right? Also not sloppy or funky sounds when you slide the fork back and forth? Got the system bled etc?

10-21-2013, 06:20 PM	#18
JL1RX7 Rotary Fanatic Join Date: Feb 2008 Location: Front Royal, VA iTrader: (1) Posts: 487 Rep Power: 17	Unless someone else might have something. I can't think of anything without dropping the tranny. Sorry dude. Any pictures of thing? Maybe the fork is the wrong way around.