|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
|
Thread Tools | Display Modes |
05-22-2013, 08:18 PM
|
#1 |
|
RCC Loves Me Not You
|
Front Cover Swaps...
Does a TII front cover directly swap over to an NA keg? My gut tells me yes, but I would like confirmation. Does the OMP stay the same?
I'm planning on ditching my scavenge pump system and go to a simple drain setup (which I've wanted to do now for years). So will it be a straight swap going from a NA front cover to a TII front cover on the S4?
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
|
|
05-22-2013, 08:50 PM
|
#2 | |
|
RCC Addict
|
Only difference should be the turbo oil drain return.
If you keep with the same series, it should be fine. Due to a change in the S5 water pump housing, you cannot run an S5 water pump housing with the S4 front oil cover. You can go vice versa, cause the S4 water pump housing doesn't have that extra protrusion. -Ted
__________________
reted_2000@yahoo.com Technical Advisor FC3S Pro http://fc3spro.com/ Quote:
|
|
|
|
|
|
05-22-2013, 10:31 PM
|
#3 |
|
Sigh.....
|
What Ted said. I'm running an S4 TII front cover on my S4 N/A block with no issues.
__________________
1986 Sport: 132k miles, 5A (Sapphire Blue Metallic), Tokico Blues, Racing Beat Springs, Custom LED tailights (only S4 LED tails in the world), SSR Mark II, Racing Beat exhaust, S5 black interior, Rotary Resurrection rebuild at 120k miles Community Service Manual RotorWiki "Imagination costs nothing; we could build square locomotives or fly to Mars" - Felix Wankel Yesterday is history, tomorrow is a mystery, but today is a gift. That is why it is called the "present." |
|
|
|
|
05-23-2013, 03:18 PM
|
#4 |
|
RCC Loves Me Not You
|
Saweet. So I take it that the OMP and what not just button right up and go. Cool. I guess I should start sourcing a TII front cover so I can figure out how I'm going to route the drain lines with some -AN fittings...
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
|
|
|
05-23-2013, 04:54 PM
|
#5 | |
|
RCC Addict
|
Yes, OMP flange bolt patterns are the same.
-Ted
__________________
reted_2000@yahoo.com Technical Advisor FC3S Pro http://fc3spro.com/ Quote:
|
|
|
|
|
Linear Mode
