s5 lim to s6 uim

low compression · 01-28-2011, 12:14 AM

Does anyone make the s5 lim to s6 uim adapter anymore. Im about ready to reassemble and am missing this important piece to the equation. Any help would be great. And yes i realized i put s5uim after posting... sorry for stupidity.

RETed · 01-28-2011, 03:17 AM

Fixed.

-Ted

djmtsu · 01-28-2011, 08:55 AM

They are not that hard to make yourself, or have a machine shop make one. Just give them an S5 and S6 gasket and say "make this work".

low compression · 01-28-2011, 06:39 PM

How thick are most of them made? Is one inch enouch? I was contemplating making it myself but dont have a saw to make a strait cut on that thick of steel. I guess i could use clean edge of stock to be part you see and use cutoff wheel on other side.

joeyfc3s · 03-13-2011, 09:20 PM

No need for a spacer,you are looking at a port matched S5 S6 combo.Some aluminum was added to the center runners and front area of the S6 manifold, then everything was port matched to perfection.

01-28-2011, 12:14 AM	#1
low compression The Newbie Join Date: Apr 2009 iTrader: (0) Posts: 25 Rep Power: 0	s5 lim to s6 uim Does anyone make the s5 lim to s6 uim adapter anymore. Im about ready to reassemble and am missing this important piece to the equation. Any help would be great. And yes i realized i put s5uim after posting... sorry for stupidity. Last edited by low compression; 01-28-2011 at 12:34 AM..

01-28-2011, 08:55 AM	#3
djmtsu My minds tellin' me no... Join Date: Feb 2008 Location: Murfreesboro, TN iTrader: (10) Posts: 4,043 Rep Power: 21	They are not that hard to make yourself, or have a machine shop make one. Just give them an S5 and S6 gasket and say "make this work". __________________ 1976 Mazda Cosmo RX-5 1976 Mazda Cosmo RX-5 2003 Toyota Tundra TRD 2015 Toyota 4Runner SR5

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-28-2011, 06:39 PM	#4
low compression The Newbie Join Date: Apr 2009 iTrader: (0) Posts: 25 Rep Power: 0	How thick are most of them made? Is one inch enouch? I was contemplating making it myself but dont have a saw to make a strait cut on that thick of steel. I guess i could use clean edge of stock to be part you see and use cutoff wheel on other side.