03-08-2010, 09:12 PM | #1 |
The Newbie
|
Differece between jspec & usspec fd3s tranny
Is there any diffrence between the jspec tranny and usspec in the 3 gen? It looks like just the 5th gear ratio is different. Is there anything else? case, mounting bolts gearing? thanks Justin
|
03-09-2010, 12:23 PM | #2 |
Rotary Fanatic
|
I don't think all of them have a different 5th gear ratio. I can't think of any subtle differences but it will bolt up and install just fine
__________________
500+ HP thanks to: Fast reacting IAT sensor thread! Mechanical Pre-turbo Water Injection Thread Dual Stock fuel pumps Thread T2 differential swap! |
03-10-2010, 03:35 PM | #3 |
RCC Loves Me Not You
|
My JDM tranny definitely has a different 5th gear than the USDM. I tested it about 4.5 years ago when I put it in...I don't remember what speed I tested at or the RPMs, but I do remember at the same speed and in 5th gear the JDM tranny was about 500 RPMs higher than the USDM.
Other than that I didn't notice any differences. Same electrical connections, bolts up exactly the same... |
04-05-2010, 11:40 PM | #4 |
Respecognize!
|
only difference should be the fifth gear.
__________________
For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage | Facebook |