|
RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
Welcome to Rotary Car Club. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
|
Thread Tools | Display Modes |
|
06-09-2009, 08:50 PM | #1 |
RCC Loves Me Not You
|
Pecuiliar vibration
has cropped up in the last two days. I've been trying to isolate it, but it very hard to tell where the vibrations are based off of. I do not really feel it until I get above 40MPH and it seems to be oscillatory in nature. This leads me to believe that it's speed based and so a thrown weight, or something to do with the suspension and not the engine forward.
This seems to be confirmed when I free rev in neutral. I don't feel any increase in vibration similar to when I'm traveling at speed. I am however still a little concerned with it as I don't feel any vibration under 40 at all. Vibrations also don't appear if I accelerate quickly to 40+. Which leads me to think that it's in the transmission/differential area. Is there any other tests I can preform in the meantime to narrow the possibilities down?
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
06-10-2009, 12:55 AM | #2 |
RCC Addict
|
If you're trying to isolate it to a certain tire, rotate your tires front-to-back.
-Ted |
06-10-2009, 07:45 AM | #3 |
RCC Loves Me Not You
|
Easier said than done. Front tires and rear tires are not interchangeable.
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
06-10-2009, 12:20 PM | #4 |
RCC Addict
|
Got a spare?
Change them out one by one after taking test drives in between? -Ted |
06-10-2009, 12:25 PM | #5 | |
RCC Loves Me Not You
|
Quote:
I'm trying to isolate it a little more than either the tires/suspension and more along the lines of isolating it by function: Engine, Transmission, Differential, tires/suspension. I don't get vibration, or at least the vibration subsides a little when I engine brake and speed is above 40. I feel the vibration comes around from the rear up through the chasis eventually feeling it in the steering wheel. At 40+ I start feeling it in the seat. I have a few things to check, and will hopefully have the car up in the air this weekend to double check the bottom of it.
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
06-10-2009, 12:45 PM | #6 |
crash auto?fix auto
|
Wheel bearings likely.
How old are the tires/rims? I would jack up the car, check all the wheel bearings and if they're tight have the wheels balanced - then go from there. |
06-10-2009, 06:15 PM | #8 |
Test Whore - Admin
|
You might even be able to see the u-joints. But the @ speed test is a good call
I had a similar vibration recently as well. It popped up on the first test drive. I could've sworn it was the wheel bearings as they had been fucked with by the previous owner that I got the 5 lug swap parts car from. So I swapped the wheel bearings. Vibration persisted. I blamed my friend for giving me a bad TII driveshaft. So we swapped that out. Still there, now I'm pissed to the point of seeing red. I had swapped in the Torsen and set the backlash myself so I knew that was good. I rebuilt the axles so those should've been fine, so in a fit of rage we swapped my rear end out. Vibration gone. The vibe must be in the pinion area. Seemed OK when I checked it out, the spermburper that sold it to me said it was in great shape, I guess I can't complain too much becuase I got an entire TII rear end, subrame, arms and a few spare axles for $200. Anyway, check the driveshaft, axles and wheel bearings. Worst case it's in the diff. Mine is going to KDR to be repaired/setup next week.
__________________
-The Angry Stig- DGRR 2009, 2011, 2012 & 2013 - Best FC DEALS GAP!! WOOHOOOO!!!!! 2015 Audi S4 - Samantha - Zero Brap S4 2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter 2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins 1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle 1988 'Vert - In progress 1988 FC Coupe - Gretchen -The attention whore BEAST! I'm a sick individual, what's wrong with you? I'm pure Evil I'm still insane, in the best possible way. I think Brian's idea of romance is using lube. Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion. You win with your thread. Most everything It's a truck with a steel gate on the back. Just a statement of fact Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff.... No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon. -Angry Motherf*cker Mode ENGAGED- |
06-11-2009, 07:23 AM | #10 |
RCC Loves Me Not You
|
I don't think so... No hard launches, not in the boost all that often or for very long as I don't have a system in place to tune for positive pressure. It's definitely from the transmission out as I still get vibration when off power and rolling. I also find that the vibrations subside a little bit when I get the car warmed up.
I'll be checking the drive shaft today. I know the diff was slightly worn when I installed it... It may infact be time for a rebuild of it. Though I can't say for certain. If I had my bore scope here, I'd drain the fluid and check out the inards for wear. From what I can tell the bearings still seem fairly firm with no play. Oh yeah. Funny story yesterday. I was doing some trouble shooting yesterday and put her in boost (Vibrations seem to subside to nill if I get weight off the front--yet to check the front bearings as I haven't had time). Heard the blow off valve for the first time and thought it was the greatest sound in the world. So I put her under boost again in hopes of hearing it... all i hear after about 2 seconds in boost is "Pssssssssssssssssssssssssssssshhhhhhhhhhhhhhhhhhh hhhhhhhhhhhhhhhhhhhh." The car then stutters to off. I popped my first coupling! Actually my idle control recirculation line popped off.
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group Last edited by vex; 06-11-2009 at 07:25 AM.. |
06-11-2009, 09:06 AM | #11 |
Test Whore - Admin
|
Lifting the front usually makes the vibration worse if the problem is in the front end somewhere
__________________
-The Angry Stig- DGRR 2009, 2011, 2012 & 2013 - Best FC DEALS GAP!! WOOHOOOO!!!!! 2015 Audi S4 - Samantha - Zero Brap S4 2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter 2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins 1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle 1988 'Vert - In progress 1988 FC Coupe - Gretchen -The attention whore BEAST! I'm a sick individual, what's wrong with you? I'm pure Evil I'm still insane, in the best possible way. I think Brian's idea of romance is using lube. Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion. You win with your thread. Most everything It's a truck with a steel gate on the back. Just a statement of fact Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff.... No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon. -Angry Motherf*cker Mode ENGAGED- |
06-11-2009, 11:33 AM | #12 | |
RCC Loves Me Not You
|
http://www.fostertire.com/tcm_vbrt.htm
Some helpful information. Seems likely that I may have some tires out of balance. Quote:
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group Last edited by vex; 06-11-2009 at 11:36 AM.. |
|
06-11-2009, 12:28 PM | #13 |
Rotary since 1972
|
Do you feel it in the steering wheel or your butt? If steering wheel it will be in the front. In you butt, engine back.
U joints possible but usually they will show through out the range. Check for bad tire, shifted belt. Bearings usually do not cause vibration unless they have really gone bad and you will hear them then. Check half shafts and installation. Rear bearings and rear you can get a good idea of any bearings by listening to them with your stethoscope. Long screw driver will work, as will a length of fuel line. Last edited by rx4ur7; 06-11-2009 at 12:33 PM.. |
06-11-2009, 01:04 PM | #14 | |
RCC Loves Me Not You
|
Quote:
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|