F.S. Judge ITO ported Irons and Rotor Housings!!!

FreeLance · 03-19-2009, 11:26 PM

Judge Ito needs no introduction. Most people know how his streetport works miracles. Eric AKA LUPE, (at the time) made 603 whp with this exact port. I'm selling the housings and the irons that came from a running motor. Before I removed the motor from the car I did a cold compression test (I know ) and had 3 perfect pulses on each rotor and both built up compression to 110psi! This pretty much states the condition of the irons and housings.

I do not have a SST to measure the wear BUT I used my dial indicator (just as good) and everything was well within spec. I unfortunately could not get an accurate sideseal measurement as it was hard to keep the dial indicator balanced flat while moving. Either way the motor made very good compression numbers COLD.

I would like $700 for all three the irons and $650 for both rotor housings. Shipping will be done VIA UPS with tracking assistance. I'm paypal verified and have sold TONS of items on the forums. I'm not doing dibs on these items. The first to paypal the funds over to mono4lamar@hotmail.com will own these babies. Thank you for looking.

-Lance Mayhon

charlies7 · 03-20-2009, 07:56 AM

Post some pictures.

03-19-2009, 11:26 PM	#1
FreeLance The Newbie Join Date: Mar 2008 Location: New York iTrader: (0) Posts: 27 Rep Power: 0	F.S. Judge ITO ported Irons and Rotor Housings!!! Judge Ito needs no introduction. Most people know how his streetport works miracles. Eric AKA LUPE, (at the time) made 603 whp with this exact port. I'm selling the housings and the irons that came from a running motor. Before I removed the motor from the car I did a cold compression test (I know ) and had 3 perfect pulses on each rotor and both built up compression to 110psi! This pretty much states the condition of the irons and housings. I do not have a SST to measure the wear BUT I used my dial indicator (just as good) and everything was well within spec. I unfortunately could not get an accurate sideseal measurement as it was hard to keep the dial indicator balanced flat while moving. Either way the motor made very good compression numbers COLD. I would like $700 for all three the irons and $650 for both rotor housings. Shipping will be done VIA UPS with tracking assistance. I'm paypal verified and have sold TONS of items on the forums. I'm not doing dibs on these items. The first to paypal the funds over to mono4lamar@hotmail.com will own these babies. Thank you for looking. -Lance Mayhon

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-20-2009, 07:56 AM	#2
charlies7 one broke moderator Join Date: Feb 2008 Location: Chicago iTrader: (2) Posts: 319 Rep Power: 17	Post some pictures.