|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
|
Thread Tools | Display Modes |
|
|
01-10-2009, 04:48 PM
|
#1 |
|
Clean S4 Nutswinger
|
PB Blaster + CAS = ??
 Last night I was spraying PB blaster on some bolts in the engine bay, and I happened to have the CAS cover off. I got a little trigger-happy and ended up getting some in the CAS. Is this bad? I dried out what I could with a paper towel (it wasn't much really). I haven't tried starting it since (main pulley is off) but could this damage the CAS?
__________________
-Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress. 
|
|
|
|
01-10-2009, 04:54 PM
|
#2 |
|
RCC Loves Me Not You
|
not likely. Damage of electrical components would come from the electric current going places it shouldn't or in too many amps. I'd recommend getting some electrical cleaning spray (basically an alcohol) and spray it in there if you're worried about it. Let it dry out and inspect it. If you're still concerned with it do an FSM test on it.
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
|
|
Hybrid Mode
