ports not matching from engine to intake

13b,ug · 12-19-2008, 12:29 AM

I have a glse 6 port engine that i plan on running in my bug. Bur I have a little bit of a problem. I recently bought a racing beat 6 port holly intake to put in this engine but the center two port are mismatched by almost 1/2in?

The ports on the intake match the gasket i have almost perfectly. So I came to the conclusion that the glse engine must have higher ports in the center than later engines? Is this right? What should i do about it run it like it is or epoxy the intake to match the engine?

PercentSevenC · 12-19-2008, 02:18 AM

It's supposed to be like that. Don't worry about it.

Rogue_Wulff · 12-19-2008, 03:52 PM

If you are refering to the fact that the ports in the engine are much taller than the ports in the intake (center iron), then don't worry about it. This is by design. The stock intake was like that, as is the RB holley style intake.
FWIW, I have a GSL-SE 6 port engine using that same RB intake, topped with an Edelbrock 600 CFM (1405) carb, and it rocks. Even with 216K on the engine, it still runs strong.

13b,ug · 12-21-2008, 10:13 PM

Thanks for the info

12-19-2008, 12:29 AM	#1
13b,ug The Newbie Join Date: Nov 2008 iTrader: (0) Posts: 6 Rep Power: 0	ports not matching from engine to intake I have a glse 6 port engine that i plan on running in my bug. Bur I have a little bit of a problem. I recently bought a racing beat 6 port holly intake to put in this engine but the center two port are mismatched by almost 1/2in? The ports on the intake match the gasket i have almost perfectly. So I came to the conclusion that the glse engine must have higher ports in the center than later engines? Is this right? What should i do about it run it like it is or epoxy the intake to match the engine?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-19-2008, 03:52 PM	#3
Rogue_Wulff Non Member Join Date: Jun 2008 iTrader: (0) Posts: 310 Rep Power: 17	If you are refering to the fact that the ports in the engine are much taller than the ports in the intake (center iron), then don't worry about it. This is by design. The stock intake was like that, as is the RB holley style intake. FWIW, I have a GSL-SE 6 port engine using that same RB intake, topped with an Edelbrock 600 CFM (1405) carb, and it rocks. Even with 216K on the engine, it still runs strong.

12-21-2008, 10:13 PM	#4
13b,ug The Newbie Join Date: Nov 2008 iTrader: (0) Posts: 6 Rep Power: 0	Thanks for the info