91 vert oil pressure issues

JL1RX7 · 06-18-2008, 12:32 AM

Ok right before I went on a two month deployment, my oil pressure gauge went all over the place. 0 to 100+psi. Didn't matter the load on the engine or anything like that. It finally settled to the top peg (100+) and hasn't moved. Even when the car is off. I cleaned the sender unit connection and the ground, but that is it. I figure it is the sender unit, but I haven't chased wires or voltages yet. So if anybody has any ideas let me know. I have about three weeks till I disappear for month again to try to get it fixed.

djmtsu · 06-18-2008, 07:34 AM

It is the sending unit. Mine did the same thing after the engine swap. When I took it out I noticed a slight ding in it, that is all it takes for it to act up.

Unfortunately for me, however, I left it connected during testing and initial start up. The gauge was pegged out and finally, it actually broke. So now I have an Autometer sender in the factory location (using an adapter from BSPT to NPT) and the gauge is above the stereo.

JL1RX7 · 06-18-2008, 09:37 AM

figured that is what it was. thanks!

06-18-2008, 12:32 AM	#1
JL1RX7 Rotary Fanatic Join Date: Feb 2008 Location: Front Royal, VA iTrader: (1) Posts: 487 Rep Power: 17	91 vert oil pressure issues Ok right before I went on a two month deployment, my oil pressure gauge went all over the place. 0 to 100+psi. Didn't matter the load on the engine or anything like that. It finally settled to the top peg (100+) and hasn't moved. Even when the car is off. I cleaned the sender unit connection and the ground, but that is it. I figure it is the sender unit, but I haven't chased wires or voltages yet. So if anybody has any ideas let me know. I have about three weeks till I disappear for month again to try to get it fixed.

06-18-2008, 07:34 AM	#2
djmtsu My minds tellin' me no... Join Date: Feb 2008 Location: Murfreesboro, TN iTrader: (10) Posts: 4,043 Rep Power: 21	It is the sending unit. Mine did the same thing after the engine swap. When I took it out I noticed a slight ding in it, that is all it takes for it to act up. Unfortunately for me, however, I left it connected during testing and initial start up. The gauge was pegged out and finally, it actually broke. So now I have an Autometer sender in the factory location (using an adapter from BSPT to NPT) and the gauge is above the stereo. __________________ 1976 Mazda Cosmo RX-5 1976 Mazda Cosmo RX-5 2003 Toyota Tundra TRD 2015 Toyota 4Runner SR5

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

06-18-2008, 09:37 AM	#3
JL1RX7 Rotary Fanatic Join Date: Feb 2008 Location: Front Royal, VA iTrader: (1) Posts: 487 Rep Power: 17	figured that is what it was. thanks!