|
|
|
||||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
|
Thread Tools | Display Modes |
|
|
06-20-2012, 10:04 AM
|
#1 |
|
member
|
injector question
I have an 84 se. If I do a mild street port it,will the stock injectors and ecu be able to handle it? or do I need to go stand alone?
__________________
leaving my carbon footprint....one start up at a time |
|
|
|
06-20-2012, 05:52 PM
|
#2 |
|
Rawr Bearclaw
|
I'd imagine you'd be fine with a mild street port. Best thing to do would be to put a wideband on it with the ported engine and see what the mixture is at. If its on the lean side you could probably get away with upping the fuel pressure a bit to compensate...although I can't see it being that lean.
__________________
Illicit Performance Rotary building, porting, tuning, chassis dyno services www.illicitperformance.com |
|
|
|
|
06-20-2012, 07:22 PM
|
#3 |
|
member
|
right now, my car has a s4 n/a engine in it and a coolant seal is blown. the original se engine that i removed can be rebuilt with just an o ring kit. i was thinking while i have it tore down,i might as well up the power a bit before i put it back together. i'm still not sure of what i'm doing yet,i'm just looking at my options.
__________________
leaving my carbon footprint....one start up at a time |
|
|
|
Hybrid Mode
