|
|
|
||||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
|
Thread Tools | Display Modes |
|
|
02-26-2012, 07:34 AM
|
#1 |
|
The Newbie
|
Help. Trouble starting
Okay, I tried to start my dads car that has been sitting in our driveway for six years. It's a 84 GSL SE. I put high octane gas in the tank after removing the gas . And starter fluid on the carburetor. I try to start it, but all it does is start for 2 seconds then dies. I did this and tried with two cans of starter, same results everytime. What should I do? Please help
Last edited by Ayoitsdavid; 02-26-2012 at 02:46 PM.. |
|
|
|
02-26-2012, 09:29 AM
|
#2 |
|
Test Whore - Admin
|
Pull start.........
__________________
-The Angry Stig- DGRR 2009, 2011, 2012 & 2013 - Best FC DEALS GAP!! WOOHOOOO!!!!! 2015 Audi S4 - Samantha - Zero Brap S4 2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter 2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins 1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle 1988 'Vert - In progress 1988 FC Coupe - Gretchen -The attention whore BEAST! I'm a sick individual, what's wrong with you? I'm pure Evil I'm still insane, in the best possible way. I think Brian's idea of romance is using lube. Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion. You win with your thread. Most everything It's a truck with a steel gate on the back. Just a statement of fact Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff.... No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon. -Angry Motherf*cker Mode ENGAGED- |
|
|
|
|
02-26-2012, 11:16 PM
|
#4 |
|
The Newbie
|
gsl-se should be fuel injected? but in either case ive had a couple of sitters that ive gotten running / asuming the pulling doesnt work within a street length... ive had to flush out bad fuel in line and replace fuel filter -if all you did was pump out bad gas out of tank and fill her up you still have alot of poor quiality fuel to pump through engine ' other things to look for would be a coolant seal that went bad and letting in small amount of coolant check your plugs after each pull ..good luck and enjoy your ride
|
|
|
|
Hybrid Mode
