need stock radio diagrams

[mazdadude7]

My harness was cut and I have a stock radio. I want to test it before I go through all the trouble of repairing the harness, so does anyone have a diagram of the plug and where everything goes, thanks

[Ender]

The FSM has some helpful diagrams. It will be in 'body electrical'.
http://foxed.ca/foxed/index.php?page...nual#secondgen

[RX_Spec]

Constant 12V+ Blue/Red
Switched 12V+ Blue/White
Ground n/a
Illumination Red/Black
Dimmer n/a
Antenna Left Rear
Front Speakers 4" Dash
Left Front (+) Blue
Left Front (-) Blue/White
Right Front (+) Blue/Red
Right Front (-) Blue/Yellow
Rear Speakers 6 1/2" Side Panels
Left Rear (+) Blue/White
Left Rear (-) Blue/Green
Right Rear (+) Blue/Red
Right Rear (-) Blue/Green

There ya go full car radio side harness!

[mazdadude7]

Thanks for all the help anyone have a picture of a plug I dont have one...

[Ender]

Originally Posted by mazdadude7

Thanks for all the help anyone have a picture of a plug I dont have one...

The FSM shows the backsides of the units where the plugs go.

[mazdadude7]

Thanks, I started to look @ the fsm but it failed to load so i didn't get to check it out yet. Thanks again though for the heads up

[Ender]

First chance you get it to load just save the whole thing so you'll have it in the future. I tried to use the link where I got my copy, but it was no longer in use otherwise I'd have given you that. If you have an S4 TII like I do send me your email address and I'll send you the FSM.

[djmtsu]

If it is an S5, you can get the factory style plugs off of MANY Mazda's from the 90's. My Millenia, Miata, and FC all used the same plugs. Some just had more pins than others.

[mazdadude7]

Thanks dj! didnt even think of that.... I knew we kept you around for a reason.

I did test the radio and it powers up fine the bulbs are blown so Im going to be replacing them with leds ,my friend has all the bulbs already and likes to do that kinda stuff.

On a different note I am working on a metal stereo pannel to fit an aftermarket radio and 3 gauges or in my case one gauge and a turbo timer. I already have a protype mocked up just gotta make a real one. I will post pics of the cardboard mock up for a few laughs later.

[djmtsu]

Ready for me to blow your mind again

DDMworks makes what you are wanting to build for a NA (1st gen) Miata that should fit FC's as well.

[mazdadude7]

My mind has been blown! your amazing!

http://www.ddmworks.com/miata/interi...surrounds.html

only thing is the mounting points are not correct but they could be fixed pretty easy.