FD 1/4 strip capable street car

BurnVktm · 01-21-2010, 10:28 PM

So I'm building my FD to be able to take to the strip and have fun with every so often, not serious competition.

Once all said and done I'm hoping to put down some mid 10sec runs. I have a few questions regarding safety regulations(NHRA), spring stiffness/use, roll cage requirements, and the difference between a 3/4/or 5 point harness in regards to what is required for certain builds?

I'm looking at going with a 4point harness, will this be ok?

sk8world · 01-22-2010, 12:21 AM

I just use my stock belts. Depends on your track requirements too.

01-21-2010, 10:28 PM	#1
BurnVktm The Newbie Join Date: Jan 2010 Location: Arizona iTrader: (0) Posts: 20 Rep Power: 0	FD 1/4 strip capable street car So I'm building my FD to be able to take to the strip and have fun with every so often, not serious competition. Once all said and done I'm hoping to put down some mid 10sec runs. I have a few questions regarding safety regulations(NHRA), spring stiffness/use, roll cage requirements, and the difference between a 3/4/or 5 point harness in regards to what is required for certain builds? I'm looking at going with a 4point harness, will this be ok? __________________ 93' FD 03' Rx-8

01-22-2010, 12:21 AM	#2
sk8world 600rwhp club member. Join Date: Mar 2008 iTrader: (2) Posts: 551 Rep Power: 17	I just use my stock belts. Depends on your track requirements too. __________________ 6.? @ 11? drag pass http://www.youtube.com/watch?v=9wfxT2RMr7c

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode