well with my concern about the greddy elbows necked down size i have since cut off the ridge and smoothed out the cut to make it 1/4 inch closer to the 3" piping dia i will get it ported out correctly when i take in my vsessive LIM to get portmatched at the same time later down the road.
and now as for the concern and issue with lower radiator mounts and 'skid plate' for it as it appears to hang low even though the intercooler is lower. heres the bracket ive come up with it will also have tabs welded on for an A/C condenser mount once i fab a kit for it. for mounting the power steering cooler i most likely will mount tabs off the intercooler. but thats for tomorrow
heres the lower radiator mount bracket and rock guard all in one it really solidly mounts the radiator just like it needs to be and will provide excelent mounting for both the a/c mounts and undertray later on when i fab those up
and heres a few of how it looks mounted....
please constructive critisizim may give me better ideas....
z
also iv trimmed the front bumper for the front mount so its ready to go back on once eveything is fabbed..... a couple small brackets need to be made still an extension for the intercooler to greddy elbow now that its beeen modded and mounting the power steering cooler line setup and putting the car back together i should be driving it again tomorrow afternoon if all goes right see how this new cooling setup works out
